Sunday 15 September 2013

SOP for operation of Ultrasonic sonicator



I.                   PURPOSE

To describe the procedure for operation of Ultrasonic sonicator.

II.        SCOPE

This procedure is applicable to Ultrasonic sonicator in Quality Control department,…

III.       RESPONSIBILITY

Executive - Quality Control

IV.       ACCOUNTABILITY
Incharge  - Quality Control
V.                PROCEDURE
1.0              Ensure that working area and instrument is clean.
2.0       Ensure that instrument is connected to the power supply.
3.0       Ensure that the distilled water is filled in ultrasonic bath up to 1/4th of the total depth. 
4.0        If water is hazy, drain the water from outlet valve provided on the right side of the           instrument and replace with fresh distilled water.
5.0        Switch on the power supply and set the timer by rotating knob.
6.0        Place the prepared solution in sonicator and keep it for few minutes until the substance     gets dissolved or the homogeneity of the solution occurs as required.
7.0        After sonication switch off the instrument.
8.0      Precautions and maintenance:
8.1                 Water should be changed every day.
8.2                 Use distilled water to avoid scaling.
VI.      REVISION SUMMARY
Version No.

Revised on

Reason for Revision

00
NA

NA

 

END OF THE DOCUMENT

No comments:

Post a Comment